Once the gateway has shown up select it, choose Network Servers from the default ones or add your own and enable it It should appear in the files folder after the upload is complete, reboot your router (System → Reboot) to install the package.Īfter the reboot, the package should be visible in the Package listĬheck if the LoRa gateway has initialized, If not, check if the USB Type is set to Mini-PCIe Once the package is downloaded and extracted, upload the LoRa package to your router. You can see the type of your routers architecture at the top of Winbox window or in System → Resources → Architecture Name Installing the version will perform a reboot.ĭownload extra packages specifically for your routers architecture and rOS version. It is Highly recommended to upgrade your RouterOS version to the latest available. Winbox can be downloaded in the link given below: Configuration GUI setupĬonnect to your router via Winbox or WebFig. Once the previous steps are done, you can close the routers case and move on to configuration. In this case UFL → SMA cable is also used, as the LtAP's case has a specific slot for it. Insert R11e-LoRa card into the mini-PCIe slot and apply two screws to the threaded inserts.Īttach antenna to the card (UFL connector) Once you have removed all the screws carefully move the upper case to the left side, as the LTE antennas are attached to the inner side of it. LtAP LTE kit will be used as example in this guide
0 Comments
Leave a Reply. |